Disco-DAW4110
Availability: Product not in stock!
Fine non-thermal curvilinear cutting
Supports other workpiece sizes
Cuts workpieces using pressurized water and abrasives
Through original technology developed to premix and discharge water and abrasives in conjunction with workpiece alignment technology cultivated from DISCO precision processing equipment including dicing saws, DAW4110 achieves high quality, high precision non-thermal curvilinear cutting. This waterjet is the world’s first waterjet saw that can be used in a clean room.
Supports other workpiece sizes
Cuts workpieces using pressurized water and abrasives
Through original technology developed to premix and discharge water and abrasives in conjunction with workpiece alignment technology cultivated from DISCO precision processing equipment including dicing saws, DAW4110 achieves high quality, high precision non-thermal curvilinear cutting. This waterjet is the world’s first waterjet saw that can be used in a clean room.
- Lowers burring and smearing of metal and resin and realizes a high-quality cutting surface
- Suppresses the smearing and delamination of laminating materials
- Positions cutting precisely using auto alignment
- Reduces abrasive scattering thus allowing operation in a clean environment
Narrow kerf width and small corner radius
DAW4110 is capable of cutting inner corners with a radius, R, of 0.3 mm by achieving a 0.3 mm kerf width using the waterjet saw. Thus, the equipment is suitable for processing narrow sections.
Abrasive recycling
Employs a recycling system to collect and recycle abrasives without drying using a premixing system.
Cuts workpieces with contour dimensions from input data
Using the automatic tool correction function, the DAW4110 can correct input data, according to measured values for the
Processing example
Cutting glass epoxy substrate with copper wiring
Supports the separation of multilayer substrates with an insulation layer thickness of less than 100 µm, such as Low-K films. Improves yield and contributes to lower cutting costs because burring and smearing are minimized.
Cutting titanium
Capable of cutting materials susceptible to cutting defects caused by processing heat, such as titanium and stainless steel.
Workability target
* Actual workability depends on the workpiece.
* The vertical cross-section surface and surface roughness may not be applicable for important workpieces.
* Partial cuts and the processing of very hard materials is not possible (such as grooving or concave processing)
* For details, please contact your local sales representative.
*Product appearance, features, specifications, and other details may change due to technical modifications.
*Please read the standard specification sheet thoroughly before use.